(X) Lighting System - ATV 200 Service Manual

¡¤ Improper installation of steering pillar bear-
ings
¡¤ Holding seat of steering pillar or sealing ring
is damaged
¡¤ Rod is bent
¡¤ Spherical connection is bent
(3) Wheel tyre
¡¤ Uneven pressure on two sides of tyre
¡¤ wrong tyre pressure
¡¤ uneven tyre wear
(4) Front/Rear tyre
¡¤ deformed run
¡¤ Loosen bearing
¡¤ Front wheel axle is bent or loosen
¡¤ Radial run out of front/rear wheel is too big
(5) Frame
¡¤ Bend
¡¤ Damaged frame
(6)Rear wheel fork
Bearing or bushing is worn
Rear wheel fork is bent or damaged

(X) Lighting system

1. Head light is out of work
¡¤ buld is trouble
¡¤ Too big load
¡¤ Charging difficulty(Lighting coil or rectifier
is failure)
¡¤ Wrong connection of wire
¡¤ Wrong connection of ground
¡¤ Poor connection(Main switch or lighting
switch)
¡¤ use-life of bult is end
2. Bulb is off
¡¤ Bulb is out of specification
- 216 -
¡¤ Battery failure
¡¤ Rectifier failure
¡¤ Wrong connection of ground
¡¤ Main switch or lighting switch failure
¡¤ Use-life of bulb is end