ATV 200 Service Manual page 198

7 N m
¢Ù
¢Ú
¢Ù
¢Û
- 192 -
4) Mount:
¡¤ Left crankcase cover ¢Ù
¡¤ Fasten screw (8 pieces)
5) Mount:
¡¤ Starting click pulley assy ¢Ù
Caution
¡¤ Fix the click pulley with rotor seat and tighten
the bolt.
¡¤ Before mounting the starting click pulley,
apply grease on oil sealing ¢Ú and O-ring ¢Û.
(¢ô )Selection and installation of adjusting
washer when mounting the crankcase.
When mounting the crankcase, output gear and
output shaft, the applied washer thickness is
determined by the actual machining dimention
of the following parts. Adjust the correct break-
50N.m
ing of the bevel gear and the clearance of every
moving parts by washer thickness.
¡¤ Crankcase
¡¤ Output gear
¡¤ Reverse gear
¡¤ Rear cover
¡¤ Forward gear
¡¤ Output shaft
When replacing above parts, must select the
adjusting washer again.
1. Mounting position of washer
A =Washer of output gear
B =Washer of forward gear
C =Washer of reverse gear
D =Washer of output shaft