ATV 200 Service Manual page 216

- 210 -
7. Fasten:
¡¤ Bolt (Installation position of engine-rear
lower)
¡¤ Bolt(Installation position of engine-rear
lower)
¡¤ Bolt(Installation position of engine-front)
¡¤ Bolt(Installation position of engine-top)
¡¤ Coupling bolt of rear arm(Rear arm shaft-
left)
¡¤ Coupling bolt of rear arm (Rear arm shaft-
ring)
¡¤ Rear arm nut
Bolt (Installation position of engine-rear lower)
33Nm(3.3m.bg.24ft.lb)
Bolt(Installation position of engine-rear upper)
33Nm(3.3m.bg.24ft.lb)
Bolt(Installation position of engine-front)
48Nm(4.8m.bg.35ft.lb)
Bolt(Installation position of engine-top)
33Nm(3.3m.bg.24ft.lb)
Coupling bolt of rear arm(rear arm shaft-left)
130Nm(13m.bg.4.3ft.lb)
Coupling bolt of rear arm(rear arm shaft-right)
0.6Nm(0.6m.bg.94ft.lb)
Rear arm nut:
130Nm(13m.bg.94ft.lb)
Bolt(rear shock absorber-top):
50Nm(5.0km.bg.36ft.lb)
8. Mount:
Dust cap of rear arm shaft
9. Connect:
¡¤ Breather tube(rear drive)
Refer to "Diagram of vehicle" in section 6 of
chapter 1.
10. Connect:
¡¤ Spark plug terminal
¡¤ CDI magneto terminal
¡¤ "Reverse" switch terminal
¡¤ "Neutral" switch terminal
¡¤ Breather tube(rankcase)
¡¤ Brake cable
Refer to "Diagram of vehicle" in section 6 of
chapter15-84