ATV 200 Service Manual page 196

¢Ý
¢Ü
¢Û
- 190 -
7) Mount:
¡¤ Output shaft ¢Ù
¡¤ Connecting claw ¢Ú
¢Ú
¡¤ Front splice ¢Û
¢Ù
¡¤ Washer ¢Ü
¡¤ N u t ¢Ý
8)Fasten
¡¤ N u t ¢Ý
Caution
¢Ù
¡¤ Fix the front splice ¢Ûwith universal joint
holder and connect the locking nut ¢Ý.
¡¤ Apply the thread fastening agent on the nut
¢ÝWhen mounting it.
9)Mount
¡¤ Rear joint and driving fork.
Mounting steps:
¡¤ Mount the relative driving fork into the splice
¡¤ Coat grease on the needle bearing
¡¤ Press every needle bearing into the front splice
with proper tube to ensure that the driving fork
is inserted into the needle bearing hole.
¡¤ Fix the hog ring into every bearing groove.
Caution
¡¤ Check every needle bearing because the needle
maybe drop out from bearing core to lose. If it
is like this the universal joint. Can' t be turned
flexiblely.
¡¤ Insert the needle bearing into universal joint
entirely to ensure the hog ring can be mounted.