ATV 200 Service Manual page 158

¢Ú
¢Þ
- 152 -
26.Remove
.All the closing case screw.
Loosen every screw1/4 circle with cross-slot
screwdriver, then remove all of them
27.Remove
.Left crankcase
.Location pin
.Disassemble the left crankcase with crank-
case separator.
.Tighten up the screw of separator, and must
keep th separator body parallel with crank-
case face. If necessary, screw the screw in
reverse direction to adjust the separator body
level.
.When appling force to case body separator,
knock the front supportor of engine, shift shaft
and balance shaft alternately and continuously.
¢Ù
28.Remove
.Long fork shaft ¢Ù
¢Ü
.Short fork shaft ¢Ú
.Shift cam shaft ¢Û
.Fork 3 ¢Ü
¢Û ¢Ý
.Fork 2 ¢Ý
.Fork 1 ¢Þ
Pay attention to position of every part, espe-
cially the position and direction of every fork.
Caution
Caution
Caution