Install Or Reseat Fuser - Xerox phaser 6250 Service Manual

Install or Reseat Fuser

■
Ensure that the Fuser is fully seated.
■
Ensure that the Fuser latches are in the fully latched position.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser Harness (FSR 4), PL 5.1.9
Warning
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 in the following troubleshooting procedure..
Troubleshooting Procedure Table
Steps Actions and Questions
1
Cycle power to the printer.
Does the error recur?
2 Check the Fuser Assembly for fault or
damage.
3 Does the error recur after replacing the
Fuser Assembly?
4 Check the Fuser Harness (FSR4) for
continuity.
See "Fuser Assembly" on page 10-21.
5 Check theFRONT 1A Harness for
continuity.
See "Fuser Assembly" on page 10-21.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Fuser Assembly" on page 10-21
Yes
Go to Step 2.
Replace the Fuser
Assembly,
PL 8.1.1
Power cycle the
printer after
replacing the Fuser.
Go to Step 4.
Go to Step 5.
Replace the Engine
Control Board,
page 8-107.
manuals4you.com manuals4you.com
No
Complete
Go to Step 3.
Complete
Replace the
Fuser Harness,
FSR 4 PL 5.1.9.
Replace the
FRONT 1A
Harness
Assembly,
PL 13.1.7.
3-41