Replacing The Vf Connector; Replacing The Illuminated Assignable Switch; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual

2-2. Replacing the VF Connector

1. Remove the CCD block. (Refer to Section 2-1.)
2. Remove the two screws, and remove the VF connec-
tor.
3. Disconnect the harness from the connector CN801 of
the SW-1071 board.
4. Disconnect the flexible card wire from the connector
CN1 of the MB-953 board.
n
Be careful not to bend the flexible card wires.
This shortens the wire life.
5. Desolder the VF connector, and replace it.
MB-953 board
VF connector
B2.6 x 5
Flexible card wire
6. Reassemble the parts in the reverse order of steps 1 to
4.

BVP-E30/E30P M-V1

CN1
CN801
SW-1071 board
2-3. Replacing the Illuminated
ASSIGNABLE Switch
1. Remove the CCD block. (Refer to Section 2-1.)
2. Remove the two screws, and remove the switch panel.
3. Disconnect the harness from the connector CN1201 of
the SW-1075 board.
4. Remove the three screws with stopper, and remove the
handle.
Switch panel
+B2.6 x 6
CN1201
Screw with stoper
+B2.6 x 6
SW-1075 board
Handle
Screws with stopper
2-7 (E)