Configuring A Logo - Extron electronics ISS 506 User Manual

Operation, cont'd

Configuring a logo

Once a bitmap is captured or uploaded via the LAN port, you can assign it to one
of the two logo locations. After it is assigned, you can position it and remove (key
out) unwanted portions of the image (such as backgrounds).
Assign the bitmap to a logo and configure the logo as follows:
1.
Press and hold Next
Press and release Logo.
Release Next.
Rotate the knobs to select
Figure 3-26 — Configuring a logo
2.
3.
N Depending on the size of the bitmap image, the Logo Position submenu may take
N If you selected Black Screen in step 3, the PIP skips the Logo Position submenu
4.
N Rotate the Adjust
3-32 ISS 506 Integration Seamless Switcher • Operation
Press and hold the Next button (figure 3-26). While holding Next, press and
release the Logo 1/Black or Logo 2/Black button (the logo to which you want
to assign a bitmap). Release the Next button.
Default
Cycle
LOGO 1
NEXT
/BLACK
30 sec.
Step
Press
1
NEXT
Logo #1 Select
Step
9.BMP
3
the bitmap image to
assign to this logo button.
upper H size
Step
2
Step
4
{
Rotate the Adjust knob to display, one at a time, all of the bitmap images
available for selection and the Black Screen selection.
Press the Next button. The Logo Position submenu appears.
a few seconds to appear.
and proceeds straight to the Logo Type screen (step 6).
Use the Adjust knobs to shift the starting point (upper-left corner) of the logo.
[
{
Rotate the Adjust knob to shift the starting point on the Y axis (vertically).
Press
30 sec.
NEXT
Logo #1 Pre Pos Logo #1 Pre Type
<
Step
X=0001 Y=0001 Level
5
Rotate the knobs to
0000 0000
select the method —
through through
luminance or color
upper V size
(RGB) — of keying
out the backround.
Rotate the knobs to
move the upper-left
corner of the logo into
the desired position.
Starting point
of logo
knob to shift the starting point on the X axis (horizontally).
Press
30 sec.
NEXT
To
>
Step
RGB Figure 3-27
7
Step
6