Powering Up; Selecting An Input; Selecting A Logo - Extron electronics IN1806 Series User Manual

Powering Up

To power on the unit, connect the provided IEC power cable between the rear panel power
connector and an AC power source. During power-up, the following occurs in the order
listed:
1.
2.
3.
4.

Selecting an Input

Press any of the input buttons on the front panel to select an input. The button lights amber.
You can also select inputs via SIS commands (see the
page 62) or PCS (see the IN1806 and IN1808 Series PCS Help File).
NOTE: The input buttons cannot select audio and video separately. To select breakaway

Selecting a Logo

The front panel
logo memory slots 1 through 6 (IN1806) or 1 through 8 (IN1808) (7 or 9 through 16 can be
selected only via SIS commands or PCS) and to enable or disable displaying the selected
logo on the screen.
To select a logo to display:
1.
2.
To deselect a logo, press the lit
from the screen.
NOTE: To configure logo key effects (such as RGB keying, alpha keying, and so
All backlit buttons (the input buttons and the
for approximately 15 seconds.
The backlit buttons light steadily amber and remain lit for approximately 15 seconds.
On IPCP models, the RTS and I/O IPCP LEDs light and remain lit.
The backlit buttons blink in sequence once, then turn off and remain unlit for
approximately 10 seconds.
When the unit is ready for operation:
The button for the previously selected input lights steadily. If audio breakaway is not
•
enabled, one input button lights amber. If audio breakaway has been selected, the
selected video input button lights green and the audio input button lights red.
If input or output signals are present, the appropriate input and output LEDs light.
•
If a logo has been selected, the
•
The green Mic and Volume LEDs light to the level previously set.
•
audio, you must use PCS or SIS commands.
button enables you to select a logo that has been stored in one of
Logo
Press and hold the front panel
containing logos light green (approximately 3 seconds). The buttons remain lit for about
15 seconds.
Press the lit button for the desired logo. The
stored in the selected slot is displayed on the screen.
on), you must use PCS (see the IN1806 and IN1808 Series Help File).
IN1806 and IN1808 Series Scaling Presentation Switchers • Operation
button) blink amber, red, and green
Logo
button lights amber.
Logo
Input Selection commands
button until the input buttons representing the slots
Logo
button lights amber and the logo
Logo
button. The button turns off and the logo disappears
Logo
on
25