Setting Up The Lan Port; Lan Port Cabling; Configuring The Lan Port; Connecting The Devices - Extron electronics IP LINK IPL T PCS4 User Manual

Setting Up the LAN Port

LAN Port Cabling

•
•
•
•
Insert Twisted

Configuring the LAN Port

You need to configure the LAN port before using it. You can configure the settings via either
SIS commands or the embedded web pages (see
"SIS Programming and
LAN port factory defaults:
Link speed and duplex:
Unit IP address:
Subnet Mask:
Gateway IP address:
DHCP:

Connecting the Devices

Connect the cables to the rear panel as follows:
1.
2.
For 10Base-T (10 Mbps) networks, use a Category 3 or better cable.
For 100Base-T networks, use a Category 5 cable.
Use a straight-through cable to connect to a switch, hub, or router.
Use a crossover cable to connect directly to a PC. Wire the connector as shown in the
tables below.
Pins:
12345678
End 1
Pin Wire Color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Pair Wires
T568A
RJ-45
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
Connector
reversed) is a "crossover" cable.
Figure 6. RJ-45 Connector Wiring
Control" for details).
Auto Detect
192.168.254.254
255.255.0.0
0.0.0.0
Off
Plug the Ethernet cable from your network into the LAN port on the rear panel.
Plug the IPL T PCS4 power cord into a wall outlet. All front panel LEDs flash on briefly;
only the power and Ethernet LEDs remain lit. (No receptacle lights should remain lit.)
NOTE:
A label covers the power receptacle on the IPL T PCS4 (US version),
reminding you that you must use the supplied 14 AWG power cord for the
PCS4 to function properly. Remove this label before connecting the power
cord to the unit.
Crossover Cable
End 2
Wire Color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
T568B
"HTML Configuration and
IPL T PCS4 • Installation and Rear Panel
Straight-through Cable
End 1 End 2
Pin Wire Color Wire Color
1 White-orange White-orange
2 Orange Orange
3 White-green White-green
4 Blue Blue
5 White-blue White-blue
6 Green Green
7 White-brown White-brown
8 Brown Brown
T568B
T568B
A cable that is wired the same at both ends
is called a "straight-through" cable, because
no pin or pair assignments are swapped.
Control" or
6