Performing A Hard Reset; Optimizing The Video - Extron electronics ISS 506 User Manual

Operation, cont'd

Performing a hard reset

The hard reset function restores the switcher to the base firmware that it was
shipped with. After a hard reset, events do not automatically start, but user settings
and files are restored. Perform a hard reset as follows:
N The hard reset restores the factory-installed firmware. The switcher reverts to
1.
2.
Figure 3-33 — Hard reset

Optimizing the Video

Perform the following steps, in sequence, after you have installed the ISS. This
procedure will help you to configure the switcher for the best settings for your
display environment. In a multi-screen environment, perform this procedure for
each display.
See "Advanced Configuration menu", earlier in this chapter, to select and output a
test pattern and to select and output blue-only video.
See "Adjusting the picture", earlier in this chapter, to make adjustments to the
picture quality.
See "User Presets menu", earlier in this chapter, to save presets.
1.
2.
N For the best results of this optimizing procedure, do not use the ISS's center
3-40 ISS 506 Integration Seamless Switcher • Operation
that factory firmware the next time power is cycled off and on unless a firmware
update is performed before the power cycle.
If necessary, turn off power to the switcher.
Press and hold the Reset button on the rear panel while you apply AC power
to the switcher (figure 3-33).
Press and hold the Reset button while you apply power to the switcher.
LAN
RESET
The switcher initializes. The LCD window shows
the model name and the firmware version and then the default display
cycle.
If you are using a digital display, such as an LCD or DLP projector, use the
alternating pixels test pattern as a reference to adjust the phase and dot clock
on the display devices.
If you are using a CRT display, use the cross hatch test pattern as a reference
to converge the display.
Set the ISS to output either the crop test pattern for 4:3 video or the
appropriate aspect ratio test pattern. Use the display's positioning controls
to position the image so that you can see all sides of the test pattern on the
display.
controls to position the image.
Power
RESET
Release the Reset button.