Configuring The Switcher; Chapter 3 • Operation - Extron electronics SW2 VGA Ars User Manual

Installation, cont'd

Configuring the switcher

There are six jumpers on the circuit board, numbered JMP5,
JMP7, JMP9, JMP11, JMP 13, and JMP15, that control connection
with one or more VSW I AAP control panels (figure 2-9 and
figure 2-10).
OPEN
All jumpers are set open (removed) by default.
The jumpers in the table below must be set closed
(installed) when a VSW I AAP is connected to the
associated input.
Close the indicated jumpers in the table below
to adjust the appropriate settings.
VSW I AAP
connected to: Jumper
Input 1
JMP5
Input 2
JMP7
Input 3
JMP9
Figure 2-1 — u per positions s VSW I AAP
input connections
These jumpers enable/disable VGA connector pin 5 (control) for
each input. Close (install) the jumper for a specific VGA input
to allow the VSW I AAP's "show me" signal to select that input.
When an input is not connected via a VSW I AAP, that
input's jumper should be in the default (open) position.
Each jumper, when closed (installed) allows the switcher to
receive the "show me" signal from the VSW I AAP on that
input's VGA connector. When a jumper is open (removed) that
input cannot receive the signal.
Auto switch mode must be disabled when using the
switcher with one or more VSW I AAP remote controls.
If the auto switch mode is enabled, the input cannot be
selected using the "show me" function.
SW VGArs / Ars Series Switchers • Installation
2-12
CLOSED
VSW I AAP
connected to: Jumper
Input 4
JMP11
Input 5
JMP13
Input 6
JMP15
SW VGArs / Ars Series Switchers
Chapter Three
Front Panel Controls and Indicators
3
Operation
Front Panel Operations