Wipe Configuration Submenu; Title Key Submenu; Pip Configuration Submenu - Extron electronics ISS 506 User Manual

Operation, cont'd

Wipe Configuration submenu

The Wipe Configuration submenu displays and allows you to set the type of wipe
that is applied (if the wipe effect is selected) and the duration of the wipe when
you are switching the preview output to the program output. (Select a wipe effect
by pressing the Transition Take button when the Effects Wipe button is lit.) A wipe
causes the new image to appear to unroll over the old image. Each wipe has hard
and soft variations. A soft wipe has a fuzzy leading edge; a hard wipe has a sharp
edge.
N You can directly access the Wipe Configuration submenu by pressing the Effects
Figure 3-10 shows the types of wipe effects that are programmed into the ISS.
Rotate the Adjust [ knob while this submenu is active to select soft (S) and hard
(H) edges for the transition effect and the wipe effect. Rotate the Adjust { knob to
select the duration of the wipe effect. The default effect is soft right.

Title Key submenu

The Title Key submenu displays and allows you to set the intensity level of the
preview image for use in the title key effect. Rotate either Adjust knob while this
submenu is active to select the title level, from 0 to 255.

PIP Configuration submenu

The PIP Configuration submenu displays and allows you to set the type of effect
(cut, dissolve, or a variety of wipes) that is applied when you pop a picture-in-
picture window (the preview output) into or out of the main window (the program
output).
Cut — The picture-in-picture window instantly appears or disappears. No
Dissolve — The picture-in-picture window fades in and fades out.
Wipe — The picture-in-picture window appears to unroll over the main image.
N You can directly access the PIP Configuration submenu by pressing the Effects
Figure 3-10 also shows the types of wipe effects that the ISS can perform when PIP
is switched on or off. Although the figure shows the effects for a whole image, the
PIP window openss or closes with the same effect.
Rotate the Adjust [ knob while this submenu is active to select a cut, dissolve,
or a variety of soft (S) and hard (H) edged wipe effects. Rotate the Adjust { knob
to select the duration of the dissolve or wipe effect (cut is immediate, with no
duration). The default effect is soft right.
3-14 ISS 506 Integration Seamless Switcher • Operation
Wipe button.
transition effect occurs.
The new image can roll in from the top, bottom, left, right, or center of the
window. A soft wipe has a fuzzy leading edge; a hard wipe has a sharp edge.
PIP button.