Title; Pip; Take And Busy; Wiping Or Dissolving In Stay Mode - Extron electronics ISS 506 User Manual

Title

X3#
Eff3*
*nnn*1*
The operator has pressed the Effect Title button on the front panel. Eff3 indicates
X3#
"title". is the key threshold. "nnn" has no meaning in this response. The "1"
after nnn indicates that this effect is selected.
displayed).

PIP

X1! X3@
Eff4* * *1*
The operator has pressed the Effect PIP button on the front panel. Eff4 indicates
X3@
"PIP". is the PIP switching subeffect. The "1" after
effect is selected.
displayed or not displayed).

Take and busy

X#
Tke1* ]
n
Bsy ]
A switching operation involving an effect (wipe, dissolve, PIP, or title) has been
initiated (Tke) and the switcher is reporting the effect's status (Bsy
issues a series of messages, the number and sequence of which depend on the effect
type and, for wipes or dissolves, the switch mode (swap or stay). See "Preview
Switch Mode submenu" in chapter 3, "Installation", for more information on swap
and stay mode.

Wiping or dissolving in stay mode

The switcher issues the following messages when you switch the input that is
applied to the preview output to the program output in stay mode with a wipe or
dissolve effect:
N The sequence of commands may vary, but you should see all of the listed
commands.
X#
Tke1*
]
Bsy1]
Reconfig1]
Reconfig2]
Bsy0]
ISS 506 Integration Seamless Switcher • SIS
X3$
]
X3$
]
X1!
is the PIP switching duration.
The switcher has received the front panel
Take command.
The switcher is performing the selected
effect (wipe or dissolve).
The input to the program output has
changed (to the input that had been
switched to preview output).
The switcher is finished performing the
selected effect (wipe or dissolve).
X3$
is the title status (displayed or not
X3@
indicates that this
X3$
is the PIP status (PIP
n
). The switcher
Programming and Control
™
4-7