Uploading Images - Extron electronics ISS 506 User Manual

Switcher Software, cont'd

Uploading images

N The IP Link File Manager must be installed on your computer to perform this
You can upload your own images to use as logos . Upload image files to the ISS as
follows:
1.
N The File Manger selection is not available (grayed out) if any of the following
2.
N
Figure 5-23 — Select Startup Mode window
3.
4.
5-22 ISS 506 Integration Seamless Switcher • Switcher Software
operation. Extron recommends that you install this program when you install
the ISS 506 Control Program. If you did not, you can downloaded it from the
Extron Web site, www.extron.com, and installed it separately.
In the ISS 506 control Program, click File > File Manager to start the IPL File
Manager program.
conditions is true:
• The Firmware Loader program is not installed on the PC.
• Your PC is connected to the ISS via a serial port link.
• The ISS is password protected and you are logged on with a user password.
If the Select Startup Mode window (figure 5-23) does not appear, proceed to
step 4:
If the Select Startup Mode window (figure 5-23) appears:
And you have not used this program while connected to this ISS before,
proceed to step 3.
And you have used this program while connected to this ISS before, click
Use Previous Setup and proceed to step 4.
Select the Never ask again checkbox to skip the Select Startup Mode Window step
from now on.
Type the ISS's IP address and, if the ISS is password protected, the password
into the Add IP Link Interface box. Click OK.
The IP Link File Manager program window appears (figure 5-24). The
window contains two major sections.
• Computer System (left section) — Displays your computer's file system.
In this section you can browse to locate files on your PC hard drive or a
server to which you have access.
• IP Link Interfaces (right section) — Displays the files that are loaded in
the ISS.