Setup Options - AMX Enova DGX 8 Instruction Manual

Setup Options

The following options are available under the Setup Options submenu:




Software Version
The Software Version Screen provides the following information:





Use the following steps to check the software version information for the Control Panel.
To check the software version information:
1. Press the Function Key.
The Function menu appears.
2. Locate Setup Options by scrolling with the Control Dial.
3. Press the Select Key.
The Setup Options submenu appears.
Locate Software Version by scrolling with the Control Dial.
4. Press the Select Key again to choose Software Version.
The Software Version Screen appears.
5. Scroll with the Control Dial to see additional Software Version information.
6. Press the Cancel Key to return to the Setup Options submenu.
Or
Press the Function Key to return to the Function menu.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Software Version – to display software version information for the Control Panel
Default VM – to change the factory default virtual matrix
Reload Config – is not used in normal operations; use only when loading local presets to the Control Panel or
when directed to do so by technical support
Change Password – to change the password from the factory default
Driver – Control Panel's firmware version
Built – date the Control Panel's software was built
Host – software version of the initial operating system (IOS) for the Control Panel
XNet ID – Control Panel's XNet device number
FP Link baud 115200 – indicates the front control panel and the baud rate
Version number
Control Panel Operation
121