AMX Enova DGX 8 Instruction Manual page 206

5. Use the tab indicated in FIG. 116 to pull the CPU board straight out of the enclosure.
FIG. 116
Use tab to pull CPU board straight out
6. Set the Position #1 DIP switch to ON (places the integrated Master into PRD mode).
Note that the DIP switch is mounted with the ON position toward the bottom.
FIG. 117
Set Position #1 DIP switch to ON
7. Slowly slide the CPU board back into the empty slot, being careful to align the edges in the board guides
along the insides (FIG. 117).
8. Push the CPU board into the enclosure firmly enough to make a good electrical connection (avoid pushing on
the connectors). When fully inserted, the faceplate on the CPU board should sit flush with the back metal.
9. Reattach the faceplate to the enclosure with the two screws that were removed in Step 3.
10. Plug in both AC power cords.
11. Check the System Status LED on the CPU for indications of normal display (see the table on the next page).
FIG. 118
System Status LED indicator
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Board guides
System Status LED
Appendix F – Program Run Disable Mode
Tab for removing CPU board
AC
AC
DC
DC
F L T
F L T
Normal mode
PRD mode
DIP switch
206