AMX Enova DGX 8 Instruction Manual page 87

DXLink Transmitter/Receiver Grounding
When using DXLink Power from an Enova DGX Switcher, we recommend wiring a technical ground for the
ungrounded sources/destinations with respect to the DXLink Transmitters/Receivers and switcher. For complete
grounding information, see the Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver.
Important: If one DXLink Transmitter or Receiver is grounded, any remaining ungrounded units that are
connected to the same board on the Enova DGX Switcher must also be grounded.
Example of Typical Setup with DXLink Transmitter and Receiver
A typical system setup for a source and a destination is illustrated below and shows an Enova DGX 16 with
DXLink Boards used in conjunction with DXLink Transmitters and Receivers for transport of HDMI signals.
This type of setup also supports DVI-D signals with the use of a cable adapter and analog video through a
Multi-Format TX, Wallplate TX, or Decor Wallplate TX.
The Transmitter receives an HDMI signal and an audio signal from a source device. The audio can be either digital
audio embedded with the HDMI signal, digital audio over S/PDIF, or analog stereo audio. Both the video and
embedded audio are transmitted over twisted pair cable to the RJ-45 connector on the DXLink Input Board. The
signal is routed through the desired DXLink Output connector to the DXLink Receiver, which in turn sends the
HDMI signal with embedded audio on to a destination device. Audio (whether embedded or not) received on the
Transmitter can be output on the stereo audio port.
DXLink Input Boards
DXLink HDMI Transmitter
FIG. 43
DXLink Boards used in conjunction with DXLink Transmitter and Receiver
Tip: For systems with special requirements – Before installing in the final location, place the equipment close
together, so a PC for control and the destination monitor can be seen simultaneously if adjustments are
necessary. Adjustments can be made using DGX Configuration Software (see page 153).
Caution: Be careful not to create a network (Ethernet) loop. To avoid doing so, see page 90.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
DXLink HDMI Receiver
Source Device
Enova DGX DXLink™ Twisted Pair Boards
DXLink Output
Boards
Destination Device
87