Attaching Wires
When attaching audio wires, you may find it easier to unplug the audio connectors before you start.
For connector details, see Audio Specifications on page 101.
Important to Know When Wiring AIE Boards
Note: If wiring the audio connectors to balanced audio input devices, see page 108 for options.
To wire audio connectors:
1. Press a very small tip screwdriver (or a T-pin) into the square hole to release the tension clamp
(if the clamp does not release fully, you may need to use the screwdriver as a lever to release it).
2. Insert the wire into the round hole.
3. Remove the screwdriver from the square hole so that the clamp places tension on the wire.
FIG. 62
Audio wiring for AIE Board
4. Test/check the Insert/Extract functionality (see below).
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Audio boards and connectors are positioned vertically on the Enova DGX 32 and horizontally on the Enova
DGX 16. Be sure to note the labeling for the wiring on the "R" (right channel) and the "L" (left channel)
wires in FIG. 62.
Enova DGX 8/16 only – the orientation of audio Insert/Extract Board in the right AIE slot places the number
1 audio connector on the far right of the board.
Enova DGX 32
Enova DGX Audio Insert/Extract Board
Tension clamp
Enova DGX 8/16
Tip: Insert a T-pin in each
of the 3 tension clamps on
one side before inserting wires.
107