AMX Enova DGX 8 Instruction Manual page 35

Attaching Cable Management Bars
If the enclosure has Epica DGX SC Optical Input and Output Boards installed, cable management bars are provided.
Caution: Do not severely bend or kink the SC fiber cable. Irreversible damage can occur. Refer to the
physical limitations (bend radius) specified for the cable by the manufacturer. The bend radius for AMX
SC terminated fiber cables is 2 inches (5 cm).
To install cable management bars:
1.
Enova DGX 32 only – Loosen the two captive screws that hold the connector numbering plate at the top of the
connectors. Remove the connector numbering plate and set aside.
FIG. 15
Connector numbering plate on Enova DGX 32
2.
Align the two screw holes on the end of the cable management bar with the two screw holes on the end of the board.
(Note the position of the long part of the bar in relation to screw holes.)
Note: On the Enova DGX 8/16, the orientation of the cable management bar is reversed from input to output board.
FIG. 16
Installation of cable management bars
3.
Insert and tighten the two screws at the end of the cable management bar (do not over tighten the screws).
4.
Align, insert, and tighten the single screw at the other end of the cable management bar (do not over tighten).
5.
Tie the cable to the cable management bar far enough from the connector to allow for the manufacturer's
recommended bend radius.
Note: The bend radius for AMX SC terminated fiber cables is 2 inches (5 cm).
6.
Enova DGX 32 only – Replace the connector numbering plate that was removed in Step 1.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Fasten cable management bar
with two screws on one end
and one on the other end
Enova DGX 32
Enova DGX 8/16
Input board
Connector numbering plate
Important: Do not over
tighten installation screws.
Tie cable to cable management
bar far enough from connector
to allow for manufacturer's
recommended bend radius
Output board
Installation and Setup
35