AMX Enova DGX 8 Instruction Manual page 21

Enova dgx digital media switchers
Hide thumbs Also See for Enova DGX 8:
Table of Contents

Advertisement

Product Overview and General Specifications
Expansion Boards
Expansion boards provide additional functionality to the system. Currently the Enova DGX Switcher has one
available expansion board: the Audio Insert/Extract Board (see page 100). This board is used in conjunction with
the embedded audio feed on the first four input or first four output boards (the standard boards must be HDMI,
DVI, or DXLink).
Note: Numbers for connectors on expansion boards are on the boards themselves not on the numbering
plate at the top which is for the standard input and output boards.
Audio Insert/Extract Boards
FIG. 11
Audio Insert/Extract (expansion) Boards – shown with a variety of video input and output boards
Depending on location, AIE Board connectors 1-8 correspond to standard
Note: Enova DGX 8 only –
input or output connectors 1-8. Connectors 9-16 are inoperable.
If the expansion board slots in an enclosure are empty, the slots can be used for expansion boards to expand the
functionality of the system. The procedure for installing/replacing an Audio Insert/Extract Board and setting it for
insertion or extraction starts on page 104.
Caution: Standard input and output boards will not fit in the expansion slots.
Important: Setting the DIP switches is the only mechanism for configuring the Audio Insert/Extract Board to
either insert or extract audio. Therefore, setting the switches (which requires removal of the board from the
enclosure) needs to be done at the time of installation setup.
Serial Numbers
The serial numbers are normally located on the rear of the enclosure on the left (for the Enova DGX 8, see FIG. 3
on page 16; for the Enova DGX 16, see FIG. 4 on page 16; and for the Enova DGX 32, see FIG. 5 on page 17).
Before installation, we recommend recording the serial number for the enclosure (and for each module and/or
wallplate if applicable) in an easily accessible location.
MAC Address
The MAC address for the system is located directly above the Control (DB-9 serial) port on the CPU.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enova dgx 32

Table of Contents