Enova Dgx Audio Insert/Extract Board - Specifications - AMX Enova DGX 8 Instruction Manual

Important: Enova DGX 32 only – AIE Boards will not work in conjunction with standard input and output
connectors 17-32, which are on the boards in the last four input and last four output board slots. Remaining
standard board slots should be reserved for input/output boards without audio insert/extract needs.
Note: The AIE Boards do not form an independent switching matrix. When an AIE Board is used on the input
side, audio signals cannot be controlled separately, but must either switch with the HDMI as embedded audio
(insert function) or are sent to supplemental audio equipment (extract function). When an AIE Board is used
on the output side, audio signals have already been switched as embedded audio with HDMI and can be
either replaced or extracted, depending on which function is set.
Enova DGX Audio Insert/Extract Board – Specifications
Applies to Audio Insert/Extract Board FG1058-700.
Enova DGX Local Analog Audio Specifications
Audio Insertion
Audio Signal Type
Analog Input Level (max.)
Input Impedance
Analog to Digital Conversion
Analog to Digital Reference Level
Optimal Analog Audio Operating Range
Connectors
Audio Extraction
Audio Signal Type
Audio Signal Type Support
Analog Output Level (max.)
Output Impedance
Output Frequency Response
Audio Output THD+N
Audio Output SNR
Digital to Analog Resolution
Digital to Analog Reference Level
Optimal Digital Audio Operating Range
Audio Synchronization
Connector
Note: Only 2 channel L-PCM audio is supported from the AIE extraction port. Multi-channel (>2 channel)
L-PCM formats will pass incomplete audio if extracted (only 2 of the multiple channels will be extracted).
All other audio formats will be muted at the extraction port.
AMX reserves the right to modify its products and their specifications without notice.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Analog stereo, up to 16 channels per enclosure
+3 dBu, unbalanced
10 kohms
48 kHz sample rate, 24-bit
+3 dBu = 0 dBfs
-30 dBu to +2 dBu
8 pluggable, dual three-position, terminal blocks each containing two
single-ended stereo contacts (supports 28 to 18 AWG)
Analog stereo, up to 16 channels per enclosure
Requires 2 CH L-PCM (32, 44.1, 48, 88.2, 96, 176.4, and 192 kHz at bit
depths of 16, 20, and 24)
+2.8 dBu, unbalanced
>=5 kohms
<+/-0.3 dB, 20 Hz to 20 kHz
<0.04%, 1 kHz, -10 dBu to +2.8 dBu
>95 dB, 20 Hz to 20 kHz, Vin = +3 dBu
24 bit, 2 Channel (stereo audio)
0 dBfs = +3 dBu
-30 dBfs to -2 dBfs
Progressive and interlaced video formats @ 60 Hz frame rate: Audio is
actively delayed to match video within 6.7 ms leading up to 9.3 ms lagging
8 pluggable, dual three-position, terminal blocks each containing two
single-ended stereo contacts (supports 28 to 18 AWG)
Enova DGX Audio Insert/Extract Board
101