AMX Enova DGX 8 Instruction Manual page 17

Enova DGX 32
MAC address
FIG. 5
Rear view of a fully loaded Enova DGX 32 enclosure with two expansion boards
Rear View Components






The following sections briefly introduce the hardware on the rear of the enclosure.
CPU/Control Board
RJ-45 ports
System Status indicator
FIG. 6
CPU/Control board
The CPU/Control board is on the left rear of the enclosure, directly below the input connectors.
Each CPU includes the following port and slot options:






Each CPU includes four LED indicators:


* The two Control ports provide direct control of matrix switcher processing (they do not work on the same layer
of control as the integrated Master, which uses the LAN 100/1000 and Program ports).
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Input boards (up to 8)
CPU/Control board
Input and output boards (some slots may be empty, depending on the configuration)
Expansion boards (optional)
CPU/Control board
Two standard redundant power supplies
Serial numbers
MAC address
Control (USB mini-B) port
Control (DB-9, RS-232 serial) port
Two RJ-45 ports – for connecting autonomous devices (linking of enclosures is not allowed)
Control port* (DB-9, RS-232) – for attaching an external serial control device (see page 54)
Control port* (USB mini-B) – for attaching an external control device (see page 56)
SD card slot – ships with an installed Micro SD memory card for CPU backup (see page 61)
Program port (USB mini-AB) – for establishing a connection from the Integrated NetLinx Master to the PC's
COM port (see page 42) and for initial setup of the system
LAN 100/1000 port (Ethernet RJ-45) – the connection from the integrated NetLinx Master to a LAN (see
page 42) for all runtime control, NetLinx programming, etc.
System Status LED (to the left of the Control ports)
Status, Output, and Input LEDs (above Program connector) – indicate system communication status and
when data is sent and received (for modes and blink patterns, see page 42)
Output boards (up to 8)
Serial numbers
MAC address
SD card slot
for system status
–
Product Overview and General Specifications
Note: If the enclosure has
any empty input or output
board slots (which are
numbered for additional
boards), they can be used
to expand the system.
If the expansion slots are
empty, expansion boards
can be added.
Audio Insert/Extract Boards
in expansion slots
Power supplies
Program (USB mini-AB) port
and LED indicators
LAN 100/1000 port
17