Embedding The Xbar Applet - AMX Enova DGX 8 Instruction Manual
Enova dgx digital media switchers
Hide thumbs
Also See for Enova DGX 8:
- Datasheet (6 pages) ,
- Quick start manual (2 pages) ,
- Instruction manual (243 pages)
Table of Contents
Advertisement
Embedding the XBar Applet
The XBar applet can be embedded in a custom website by using the applet tag shown below.
Make any of the following adjustments to the code to fit your particular system's requirements.
Important: If you do not want either or both of the "Allow Gain" and "Allow Volume" options, omit those
parameter(s) entirely.
XBar Applet Tag
<HTML>
<BODY>
<!-- Your custom html code goes here. -->
<APPLET code="CrossBar.class" codebase="http://192.168.0.251"
archive="CrossBar.jar" width=400 height=500 >
<param name = "InitialVM" value = "0">
<param name = "VMLockDown" value = "locked">
<param name = "AllowGain" value = "true">
<param name = "AllowVolume" value = "true">
</APPLET>
</BODY>
</HTML>
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Replace the code base value with the IP address for your system.
Set the width and height for the display based on the initial virtual matrix size (smaller VMs look fine in a
smaller size, while larger VMs require a larger size to minimize scrolling).
Optional – Specify the "InitialVM" value, or the lowest numbered VM will display by default.
Optional – Include the "VMLockDown" information if you want to limit control to a particular virtual matrix;
otherwise, all virtual matrices will be accessible from the VM title block. Specify "locked" or "unlocked" for
the value. The XBar defaults to the unlocked state if this option is not included in the tag.
Optional – Specify the "AllowGain" value, if you want the input gain adjustment feature enabled. Specify
"true" for the value.
Optional – Specify the "AllowVolume" value, if you want the output volume adjustment feature enabled.
Specify "true" for the value.
Firmware Upgrade & Info for Network Admin
143
Advertisement
Table of Contents
Troubleshooting
