AMX Enova DGX 8 Instruction Manual page 92

To connect sources and destinations to DXLink inputs and outputs via TX/RX:
1. Attach an HDMI cable from the source device to the HDMI connector on the DXLink Transmitter.
2. Attach a twisted pair cable to the DXLink Transmitter's Output (RJ-45) connector.
3. Attach the other end of the twisted pair cable to the input connector on the DXLink Input Board.
FIG. 47
Fasten cables onto input and output connectors
4. Attach a second twisted pair cable to the output connector on the DXLink Output Board.
5. Attach the other end of the second twisted pair cable to the Input (RJ-45) connector on the DXLink Receiver.
6. Attach a second HDMI cable to the HDMI Output connector on the Receiver.
7. Attach the other end of the second HDMI cable to the destination device.
8. Repeat steps above for additional source and destination devices.
9. If the enclosure is not being used as the source of power, attach the provided desktop power supplies to the
transmitters and receivers.*
10. Apply power to the source and destination devices.
* If the enclosure already has power applied, as soon as transmitters and receivers are connected they will have
power.
Note: DXLink Boards can also work in conjunction with Audio Insert/Extract Boards (see page 100).
DXLink Connector LEDs
The following information applies to the LEDs on the DXLink connectors on the DXLink Input and Output
Boards.
FIG. 48
DXLink connector LEDs (left Enova DGX 32 board orientation; right Enova DGX 8/16 Output Board orientation)
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Green LED
Yellow LED
Yellow LED
Enova DGX DXLink™ Twisted Pair Boards
Yellow:

On – Authenticated HDCP

(handshaking has occurred
successfully)
Flashing – Video active; no HDCP

Green LED
Off – No video

Green:

On – Speed status is 100 Mbps

Off – Speed status is 10 Mbps

92