AMX Enova DGX 8 Instruction Manual page 217

set command
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Basic DGX_SHELL Commands (continued)
set This command displays a list of configuration variables indicating the current setting. The variable's
setting can be altered.
aie_broadcast=ON
bdf_writeprotect=ON
com1_baudrate=9600
com1_flowcontrol=0
datetime_broadcast=ON
datetime_dst=OFF
datetime_dst_offset=3600
datetime_tz_offset=0
debug_port=UNSET
event_logfile=1
master_dns_ip_assignment=OFF
master_ip_address=0.0.0.0
master_subnet_mask=0.0.0.0
master_default_gateway=0.0.0.0
remote_timeout=15
shell_timeout=244 (maximum value 244)
shell_start_cmdstr=bcs; su admin password
shell_stop_cmdstr=exit
sm_capable_check=1
syslog_server_ip_address=0.0.0.0
BCPU2 vars unavailable
Usage: set {-d}{-v}{<name>}{=}{value}
Options:
-d default
-v verbose Print the variable's description and syntax.
Target (target names contain a following underscore):
BCPU_
BCPUx where x = 1-16 for Enova DGX 32; x = 1-8 for Enova DGX 16; x = 1-4 for Enova 8
CENTER use for an Enova DGX 8/16 or to target all centers in an Enova DGX 32
CENTER_x where x = 1-4 for an Enova DGX 32
PPIC_
EXPIN_ (AIE expansion board on input side of enclosure)
EXPOUT_ (AIE expansion board on output side of enclosure)
EXPCPU_
Note: For additional information on datetime variables, see page 210.
show This command displays version information for the MCPU and the BCPUs.
help show This command lists the variables that can be used in conjunction with show to display hardware and
firmware information for the enclosure and each of its boards.
Usage: show {aie | bdf | status | stats | version | fwid | announce}
The show <variable> commands display data that can be used to assist technical support in
troubleshooting the system.
Example response for show fwid (firmware ID):
<00000600|00001050|00001050|00001040|00001040|00001070|00001080|00001070|
000010B0|00001030|00001030|00001030|00001030|00001010>
Note: The broadcast setting for the AIE Boards can be enabled or disabled by entering:
set aie_broadcast=ON or set aie_broadcast=OFF (The default state at boot up is ON.)
Restore the variable's default value.
Appendix H – DGX_SHELL Commands
217