Enova Dgx; Rack Installation And System Setup - AMX Enova DGX 8 Instruction Manual

A typical system setup for a source and a destination is shown on page 97 and has an Enova DGX 32 with DGX SC
Optical Boards used in conjunction with DGX Fiber Modules.
The DGX HD-15 and DGX DVI Transmitter Modules can be installed interchangeably. The DGX HD-15 and DGX DVI
Receiver Modules are interchangeable as well, providing for an extremely flexible system. For example, in the same
system, a source device can send a DVI signal and the destination device(s) can receive an RGBHV signal.
Note: In addition to the system setup options listed in the table on the previous page, optical signal flow
between Enova DGX Switcher and Epica DGX 16/32/144 enclosures (from SC fiber connector to SC fiber
connector) is supported. Contact your AMX representative for these and other system design possibilities.

Rack Installation and System Setup

Enova DGX Switchers can be mounted in a standard EIA 19 in. (48.26 cm) rack.
Required Items for Rack Installation:






Optional Items for Rack Installation:
 
Installation Recommendations:




Safety Recommendations for Laser Products
Important: No user serviceable parts are included inside Enova DGX Switchers; service should only be done
by qualified personnel.
Caution - Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Exercise caution when installing Epica SC Fiber products to avoid direct eye exposure to invisible laser radiation.
Follow the recommendations below whenever installing or working with Epica SC Fiber products.
 
 
 
 
 
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Enclosure
Standard EIA 19 in. (48.26 cm) rack
Screwdriver
Screws that fit your rack for mounting the enclosure
Power cords
Surge-protector – highly recommended
A PC or laptop computer with a null modem cable for communication with the enclosure via the
RS-232 serial (Control) port
Write the serial numbers (normally located on rear of enclosure) in an easily accessible location before
installing the enclosure in a rack.
Use an earth-grounded power cord / system with an Enova DGX Switcher.
Attach all power cords to a single surge protector and/or an AC line conditioner.
Apply power to the Enova DGX Switcher before applying power to its source and destination devices.
Be sure to apply the power only after all the fiber connections are made and no fiber ends are exposed.
Do not remove dust plugs from Epica SC fiber connectors or the dust caps from the fiber cables until
establishing connections; avoid direct eye exposure.
Make sure all cables, including fiber cables, are correctly connected and/or terminated.
Before you unplug a fiber cable on an input board, disconnect the power on the DGX TX that is
connected to the input.
Before you unplug a fiber cable on an output board, disconnect the switch for that output connector.
Installation and Setup
32