Chapter 1. SRX-Pro Server
Setting up SRX-Pro (DVMS models only)
Step 2: Plug the monitor cable into the VGA connector on the video card (or on the motherboard for the DVMS systems
with on-board video only)
Step 3: Connect the BNC Cables to the BNC Ports on the BNC board in the back of the unit or to the BNC ports on the
video pigtail cable. Begin connecting the BNC video cables to the i³ server's BNC ports. Ensure they are secure and locked
into position. Once completed, ensure that the 75O impendance dip switches are in the upward position. This is necessary
in order to terminate the video signals.
NOTE: The dip switch terminals are located below the Loop Out port on the Rackmount, and below the video in/out
ports on the Compact Wallmount chassis.
5