i3 International SRX PRO User Manual page 108

Chapter 1. SRX-Pro Server
2. Enter a descriptive name for the selected detection area in the Area Name: field. In the example below, Area No. 1
is called "warehouse".
3. Check off Send E-Mail checkbox to have an emergency Email sent every time an alarm is triggered in this Area.
The email address is taken from the Email Setup tab. Make sure to configure E-Mail setup tab.
4. Check off Control checkbox to activate selected control every time an alarm is triggered in this Area.
5.
Click the Browse button
Setup tab will be displayed.
6. Set the working [Time] for the selected control. After the control has been activated, it will remain on for the set
period of time. In the example above, Control 1 will remain on for 5 seconds after the motion has been detected in
the Area No. 1.
7. Check off Enable Sound checkbox to enable custom audio alarm for the selected area.
8.
Click the Browse button
9. Locate the *.wav sound file and click Open
10. Set Duration of Sound by adjusting the slider (1 sec - 99 sec) to determine how long the *.wav file will play.
11. Set Background Refresh Delay (1s - 1800s). If Intelli-Guard™ detects no changes in the monitored area, it will
update the area picture according to the selected schedule. This will decrease the cumulative image difference caused
104
to select the desired control from the list. Only controls activated in the Hardware
to select the desired *.wav sound file from the hard drive.
Intelli-Guard™ Setup