Ip Camera - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server
selection.
OR
Check off the Covered by Original Image checkbox and click Save in the bottom of the screen to capture the
current image within the drawn area and use it as a masking image. To update the original image, click Save
again.
6. Configure Time Selection to only use the configured masking during the selected time. By default, configured
masking feature is active all the time.
• Configure Begin/End active date and time for masking option
• Configure Repeat option if desired
7.
Click the Save button to save the configured settings
The settings apply to the selected channel only. To configure VideoPrivacy for another camera, select the desired
camera and repeat the previous steps.

1.4.21. IP Camera

1.4.21.1. Overview
The SRX-Pro Server software supports a number of IP modules and IP cameras. Before using the SRX-Pro Server, all IP
modules and IP cameras must be properly installed and configured. Refer to the respective manuals in order to properly
configure the IP cameras/modules first.
The user will need WAN or LAN to connect to IP cameras/modules. WAN/LAN must be properly configured by the network
administrator before using SRX-Pro Server software.
Even though the IP modules located on WAN are supported, it is highly recommended to use IP modules on LAN ONLY.
Since the Internet connection is less reliable than the network connection, the video recording is a lot more stable and
reliable on LAN.
Currently SRX-Pro Server supports the following IP modules: ANNEXXUS 101M, 104, 204, 304, 301, 301C, 301C2M,
301D2M, 316, 401C1M, 401C1MN, 401D1M, 401PTZ. Note that by connecting analog cameras to ANNEXXUS 104,
204, 304, and 316, their PTZ capabilities may still be used.
124
IP Camera