Motion Setup - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server
Caution
Unless Motion recording is set in the
Schedule Setup, the channel will not record
and motion will not be detected even if the
Motion detection target zones are con-
figured for this channel.
Note
Motion detection must be enabled in order
to use emergency frame rate recording with
the selected channel. Emergency frame rate
will not be used if the motion detection is
disabled on a desired channel.
2. Specify Dwell(Sec) time for the sequence. Dwell(Sec) refers to the interval (in seconds) between each video input
in a sequence. In this example, each video input will be shown on the spot monitor for 3 seconds.
3. Check the Spot Monitor Follow Main Screen checkbox to associate the spot monitor with the SRX-Pro Server
Main Screen, if desired.
If Spot Monitor Follow Main Screen is unchecked, the spot monitor will display selected video source inputs
one-by-one in a sequence.
If Spot Monitor Follow Main Screen is checked, the selected sequence will continue until a channel is displayed
in the full screen mode of the SRX-Pro Server's main screen: manually by user or in response to detected motion
(Motion Setup). The sequential switching pattern will then be interrupted temporarily to display the channel currently
in the Full Screen mode. After the configured Dwell(Sec) time elapses, the spot monitor will return to the original
sequence. In this example, after displaying the channel currently in full screen mode for 3 seconds, the spot monitor
will continue showing cameras 4, 9-12 in a sequence, 3 seconds apart.
4.
Click the Save button to save the configured settings
Related Topics: Hardware Setup-Channel Settings

1.4.5. Motion Setup

1.4.5.1. Overview
Motion Setup allows for the configuration of motion detection zones for each channel. Each target zone can have its own
motion detection configuration.
64
Motion Setup