i3 International SRX PRO User Manual page 107

Chapter 1. SRX-Pro Server
1.4.14.2. Suggestions for using Intelli-Guard™
1. Before setting a defining area, experiment with the specific location to test the parameter settings. Make sure that
Intelli-Guard™ works as expected. Test both real alarm and false alarm situations. Adjust the settings to minimize /
eliminate the number of possible false alarms.
2. It may be difficult to achieve good results if the image video contrast is low. Adjust the image brightness and contrast
in the Video Setup tab to achieve better results.
3. Intelli-Guard™ is best used in an environment with little color variation. For instance, if the monitored object is placed
on a one-color background, any change (e.g. an intruder) will be noticeable, therefore easily detectable.
1.4.14.3. Creating Intelli-Guard™ detection area(s)
Each detection area has its own configuration and has to be saved individually. Up to 5 detection areas can be configured.
Each detection area can have its unique set of settings, including Active Time, custom alarm file, control, etc. To switch
between detection areas, select the chosen detection area by clicking on the desired green box in the live view window.
Selected detection area will be highlighted in red.
To create Intelli-Guard™ detection area, do the following:
1.
Select the Channel # in the Current Channel frame. Click the Browse button
from the list, selected channel will be displayed in the live view window.
2. Configure Interval Alarm by adjusting the slider. In the example above, Interval Alarm is set to 400ms. Interval
Alarm is configured on per channel and not per area basis. Interval Alarm setting determines the time that passes
between the motion occurrence and motion detection.
3. Create the detection area(s) in the live view window.
a. Place the mouse cursor at the start point over the live view window
b. Hold down the left mouse button and drag the cursor to draw the rectangular detection area
c. Let the mouse button go
d. Adjust or move the created detection area if necessary
4. Click Area Draw to set the entire channel screen for motion detection
5. Click Area Clear to reset all detection area on a selected channel
6. To delete a specific detection area, select the area by clicking on it, hold down the left mouse button and drag the
area to remove it from the live view screen.
7.
Click the Save button to save the configured settings
1.4.14.4. Configuring Intelli-Guard™ detection area(s):
To configure selected Intelli-Guard™ detection area, do the following:
1. Select desired detection area in the live view window. Settings for the selected detection zone will be displayed in
the Area No. frame.
103
Intelli-Guard™ Setup
to select the desired channel