Liebert® Multilink™ Viewer Configuration - i3 International SRX PRO User Manual

Chapter 3. Appendix
Caution
AN UNINTERRUPTIBLE POWER SUPPLY
(UPS) (MIN. 500VA) MUST ALWAYS BE
USED; OTHERWISE ALL WARRANTIES WILL
BE VOIDED.
Tip
Default password for i3dvr master user is
i3dvr.
3.4. Liebert® MultiLink™ Viewer Configuration
Liebert MultiLink is an i³-recommended Uninterruptible Power Supply (UPS) product. This section describes how to con-
figure Liebert MultiLink UPS to safely shut down SRX-Pro Server and the DVR without corrupting the video data in case
of the power failure. To prevent damage to the recorded data during the power outages, i³ has developed a shutdown
command to shutdown the DVR correctly without shutting down the SRX-Pro Software in the middle of the recording
process.
Requirements:
• SRX-Pro Server version 1.401.16/1.402.32 or higher
• Liebert UPS installed and successfully connected to the SRX-Pro Server
• Liebert MultiLink Advanced Shutdown v3.5 installed on the DVR
Follow these instructions on the DVR system:
1. Exit SRX-Pro Server software and access the Desktop by pressing Ctrl+Alt+Shift+F4 on the keyboard. Enter the
master user password to close the software.
2. On the Desktop click Start -> Run...
3. Type cmd in the Open: field
4. A command prompt window will appear.
5. Type the following commands inside the command prompt window:
a. Type cd \i3pro server
To go to the SRX-Pro Server folder
b. Type shutdownsrxpro –c
To create an encrypted configuration file
c. Enter master username and password for SRX-Pro Server when prompted
Ask your network administrator for SRX-Pro Server master user account login information. Default is i3dvr/i3dvr.
d. Wait for the following message "Configuration file has been generated!" is shown in the image below
e. Type exit
To close the command prompt window
206
Liebert® MultiLink™ Viewer Configuration