i3 International SRX PRO User Manual page 69

Chapter 1. SRX-Pro Server
Note
The area settings are configured individually
for each motion detection area.
1.4.5.2. Setting up a target zone for motion detection
To set up a target zone for a specific channel, do the following:
1.
Select the Channel # in the Current Channel frame. Click the Browse button
from the list, selected channel will be displayed in the live view window.
2. Draw the motion detection zone on the selected channel.
a. Place the cursor at the starting point on the live view screen
b. Hold down the left mouse button and drag to draw a rectangular area. Adjust the area if necessary
c. Repeat steps 1-2 to configure up to 5 (five) motion detection areas.
3. OR Click Area Draw to set the entire channel screen for motion detection. Click Area Clear to reset all motion
detection zones on a specified channel
4. Select the desired motion detection area on the live view screen to activate the area settings. The selected area is
highlighted in red. If the entire channel screen is configured for motion detection, click inside the live view screen to
activate area settings.
5. Set the Sensitivity for the selected motion detection zone. The higher the Sensitivity, the less change in an image
is needed to set off the alarm. If the Sensitivity is set to Low, the change in an image will have to be dramatic to be
detected as motion. This function only works properly indoors. The natural changes an outdoor environment (e.g.
clouds) can cause false alarms.
6. Check the Alarm checkbox to enable the internal speaker alarm for selected motion detection zone
7. Set the Alarm active time. If motion is detected outside of the active time, the Alarm will not go off. In this example,
the Alarm is active from 7:30AM to 8:20PM on Area No. 1 on Channel
8. Check the Control checkbox to enable a control association for the selected motion detection area.
9. Choose the control number to be associated with the motion detected in the selected motion detection area. In the
example above, Control 2 will be activated if motion is detected in the Area No. 1 on Channel 1.
10. Set the [Time] for the Control feature. This is the length of time that the control will stay on, if activated by motion
detection. In the example above, the Control 2 will stay on for 5 seconds if motion is detected on Area No. 1 on
Channel 1.
11.
Click the Save button to save the configured settings
Full Screen on motion function
65
Motion Setup
to select the desired channel