Two-Way Audio - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server
4. Repeat step 2 to configure the Auto Pan end point
5. Right-click the channel number on the PTZ Control Wheel in the Advanced Control Panel and select Set Point2 in
the context menu
6. Right-click the channel number on the PTZ Control Wheel again to access the context menu
7. Select Auto Pan Start/Stop to start auto panning. The i3DVR Speed Dome will now continuously mode between
configured Point1 and Point2.
8. To interrupt Auto Panning, repeat steps 7-8
Related Topics: Hardware Setup-Channel Settings | Intelli-Zone™

1.3.8. Two-way Audio

Two-way audio feature allows SRX-Pro Server to communicate with SRX-Pro Remote via voice connection. Speakers/head-
phones and microphone are needed on both sides to establish a voice connection. Two-way audio connection is always
initiated by SRX-Pro Server, however SRX-Pro Remote must be connected to the Server at the time of the two-way
connection initiation.
Two-way audio feature utilizes on-board audio input both on Server and Remote side. It is the user's responsibility to
ensure that the microphone is properly plugged into the Mic port and that the speakers/headphones are plugged into the
Line Out port on the motherboard.
Two-way audio communication is not automatically recorded on either side, however, on SRX-Pro Server side, the on-
board audio may be shared between 2-way audio feature and audio recording. To record the Server side of the voice
communication, associate the on-board audio with one or more video channels in the Hardware Setup tab.
To establish a two-way audio connection between SRX-Pro Server and Remote, do the following:
1.
On the SRX-Pro Server, click on the 2-way Audio button
Server window. At least one remote client (SRX-Pro Remote) must be connected to the SRX-Pro Server to establish
2-way audio connection.
56
Two-way Audio
on the Main Screen to display the 2-way Audio