i3 International SRX PRO User Manual page 57

Chapter 1. SRX-Pro Server
Tip
A default name is used for all new patterns.
The pattern(s) can be optionally renamed
by the user.
1.3.7.5. Programming Pattern(s)
Pattern is a custom path of the speed dome from start point to end point and back. This is different from the preset
touring, where camera switches between the maximum of 10 configured presets. Pattern records every movement of
the speed dome, therefore, the user must be precise, when creating a new pattern to avoid unwanted speed dome
movements.
To create speed dome pattern, do the following:
1. Enter PTZ mode by double-clicking the PTZ channel on the main screen
2. Make sure that the software is in either Advanced or Tree view. To check, click View menu
3. Click the Advanced Control panel in the SRX-Pro Control Center Right to expand it
4. Configure the pattern start point same as preset via PTZ Advanced Control panel and/or in-cameo mouse function.
(See Programming Presets for more information)
5. Right-click inside the Patterns field
6. Select Create Pattern -> Set Pattern Start from the context menu. The pattern start point has been saved.
7. Create a custom speed dome path that covers all desired locations. Remember that Pattern function is recording
every move from the time Set Pattern Start has been clicked.
8. When finished, right-click inside the Patterns field
9. Select Create Pattern -> Set Pattern End to complete the Pattern recording. The following message will be
displayed:
10. To save created pattern, click Yes. By default, the new pattern will be immediately activated. To stop the pattern,
click on Patterns drop-down menu and select NONE.
To rename created pattern, do the following:
1. Select the desired pattern in the Patterns drop-down menu
2. Right-click inside the Patterns field
3. Select Rename Pattern from the context menu
4. Type the custom preset name in the Patterns field
To delete created pattern, do the following:
53
PTZ mode