Video Privacy Setup - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server
Tip
The number of vehicles passed and the stay
time for each vehicle is embedded in the
video recording and can always be seen on
the live image and during the playback.
These counters will only be displayed after
the Save button is clicked.
Important
The counter will be reset every midnight.
a. Only one area can be drawn. Note that the area, where a region can be drawn is limited by four red dots on the
live image
No more than 39 points can be used in the polygon shape
b. Draw a polygon region around a sedan-type car
c. Double-click or click on the first point to complete a polygon shape
d. Right-click or press Esc to delete created points before a polygon shape is complete
5. Adjust the drawn region or move it to desired position if necessary
To delete the drawn region, click Clear
6. Name the drawn region in the Area Name field
7. Select the Transaction Channel from the drop-down menu. This camera number indicates which camera can be
used by POS for drivethrough transaction. The selected transaction camera must be different from the current Vision-
Count channel.
8. Configure Active Time for the drawn area. The DriveThrough counting will only work within the set Active Time.
In the example above, DriveThrough is only active from 7:00AM to 11:00PM.
9. Check off the Count All checkbox to count each vehicle that enters the drawn region
OR
Uncheck the Count All checkbox and enter desired Period of Time in minutes and seconds. This function counts
vehicles based on the period of time they spend inside the drawn region.
E.g. To count vehicles that remain in the drawn region for more than 60 seconds, enter 60 seconds in the Period of
Time section. The purpose of this would be to determine how many drive through customers took longer than 1
minute to service. This may be useful for drive through standards reporting. I.e. If the manager requires the cashiers
to service each drive through customer in 45 seconds or less, they can count all discrepancies in the end of each shift
using this counting function.
The period of time can be configured to a maximum of up to 59 minutes and 59 seconds.
10. Click the Save button to save the settings
The settings apply to the selected camera only. To configure another camera for DriveThrough, select the desired
camera and repeat the previous steps.

1.4.20. Video Privacy Setup

Video Privacy Setup setup allows masking of up to two polygon or rectangular areas on each selected channel. The
masking option can be used to obstruct the view of unwanted areas inside the camera's field of view. Note, however,
that if the camera in question is a PTZ camera, the masking will remain static and will not be adjusted if the user
pans/tilts/zooms the camera from its original position.
122
Video Privacy Setup