E-Map Setup - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server
Important
This function is not supported by SRX-Pro
Remote
Tip
Any one specific channel/control/sensor can
only be used once
5. Wait for the following message to be displayed in the top left corner:
6. Wait for the following message to be displayed in the top left corner. Click OK to finish.

1.4.12. E-Map Setup

1.4.12.1. Overview
The E-Map function allows the users to lay out channels on a map for the quick launch of a specific channel. Positioning
of the channels, controls and sensors is done on an existing digital drawing/map. The map appears on the main screen
and allows quick access to the desired channel by simply clicking on its representative icon. Clicking on a channel's icon
will display the image of that channel in full-screen mode.
Note that E-map does not allow manual activation of a control. However, if a control/sensor is triggered, it will be registered
on the E-map: the icons representing the sensors/controls will be animated. E.g. If the control is activated, the control
icon on the E-map will flash.
96
E-Map Setup