i3 International SRX PRO User Manual page 64

Chapter 1. SRX-Pro Server
Note
The number of supported IP channels is
SPK-dependent.
Note
The number of supported audio channels is
SPK-dependent.
Tip
Fixed cameras do not have a Cam. ID.
Tip
The BNC connector number does not have
to match the Cam. ID number.
To setup all connected video sources, do the following:
1. Check the All checkbox to enable all channels OR enable desired channels by checking individual channel checkboxes.
2.
In the Video field, click the Browse button
(analog/IP cameras). The input number corresponds the number of physical BNC connector in the back of the DVMS.
IP camera inputs are distinguished by IP address. (See IP Camera setup section on instructions on adding IP cameras
to the Video Source list). Select desired video input to display on the corresponding video channel.
3.
In the Audio field, click the Browse button
on the DVMS, on-board audio can be used. Select desired audio input to be used with the corresponding video channel.
See Audio Recording in Search Mode section for information on playing back the audio recording.
4. Assign a descriptive Name to each channel. For example, the channel could be named based on the video source
location (e.g. Front Door).
5. Adjust video Compression Quality. The lower the number, the higher the compression (20% - best compression,
100% - best quality).
6.
Choose the correct PTZ Camera Type for all connected PTZ video sources. Click the Browse button
the list of supported protocols. If the wrong protocol is selected, the camera may not respond to user commands.
The following PTZ camera protocols are supported: BOSCH, Checkpoint, ELMO: PTC Series, ELMO: Speed
Dome, I3DVR 302, I3DVR SD, I3DVR Z1200, I3DVR Z2200, Panasonic CS854, PELCO-D Mini, PELCO-
D SpecII, PELCO-D SpecIII, PELCO-P SD.
7. Enter Cam. ID number for each channel that has been assigned a PT/Z camera video source. Cam. IDs help to distin-
guish between the different PT/Z cameras connected to the same parallel connection. Most Speed Domes have their
Cam. ID assigned by dip-switches in the back of the camera; Camera ID for zoom cameras is normally assigned through
camera menu. Cam. ID must match that of the assigned Video Source. If the Cam ID. has been entered incorrectly,
the PT/Z camera will not respond to user commands.
The PTZ cameras are controlled based on the entered Cam ID. For example, if the Cam ID. for Input 1 is assigned to
Input 2 in the Hardware Setup, Input 1 will be controlled when the user attempts to control Input 2 from PTZ Advanced
Control Panel.
8. Check the A/P (Auto-Pan) checkbox for the installed Speed Domes. This feature allows the speed dome to return
to the programmed auto pan after the PTZ settings have been adjusted remotely.
9. Assign Dwell time for the A/P setting. This is the time that will pass before the Auto-Pan (A/P) feature will be activated.
In the above example, Channel 1 will return to the original pan after 30 seconds.
10. Click Defaults to assign default video source to each channel. By default, video sources (cameras) 1-16 will be assigned
to channels 1-16 in a sequence. All configured IP cameras (if any) will be assigned to the channels 17-32. If no IP
cameras have been configured, channels 17-32 will be assigned no video source.
to display all available video sources connected to the DVMS
to display all available audio inputs. If audio card is not installed
60
Hardware Setup - Channel Settings
to see