E-Mail Setup - i3 International SRX PRO User Manual

Chapter 1. SRX-Pro Server

E-Mail Setup

7. The smaller the division value, the more divisions there will be on the ruler. The SRX-Pro Server will automatically
adjust the division value if the length of the ruler can not be equally divided by the specified Length of Division value.
8. In the Unit section, select the desired unit of measurement: feet, inches, meters, etc.
1.4.23.2.1. Drawing a Virtual Ruler
1. Physically measure the height or the area covered in the camera view
2. Draw a mark(s) on that area to signify the start and end points of the ruler
3. Using the mouse, move the cursor to the live view window in the Virtual Ruler Setup tab
4. Hold down the left mouse button, and drag it in a straight line
5. Adjust or move the ruler if necessary. To erase the ruler click Clear.
Example,
For example, the height of the door entrance is exactly 84 inches. The ruler starts with 0 (floor) and ends with 84'' (top
of the entrance). The unit of measurement is inches. Originally, the Length of Division value entered was 10, however,
84 cannot be equally divided by 10, and therefore the SRX-Pro Server adjusted the value to 10.5. Therefore, 84''/10.5''
= 8. The ruler is divided into 8 equal parts, with the value of one division equal to 10.5 inches.
1.4.24. E-Mail Setup
This Setup tab allows the sending of an alert via email when a sensor is triggered, or when a video signal has been lost.
It can also send the status of the Server by sending a screen shot from a specified channel.
140