i3 International SRX PRO User Manual page 145

Chapter 1. SRX-Pro Server
Tip
Sensors must be enabled and configured in
the Hardware Setup.
Note
A first e-mail is sent after changes to this
setting are saved and on the SRX-Pro Server
startup. The SRX-Pro Server will then send
e-mails according to the set schedule. In the
above example, every hour.
There are four ways to send an email alert:
1. Triggered Sensor(s)
Select appropriate sensors in the Enable Email For Sensor frame. Whenever any of the selected sensors are
triggered, an e-mail alert will be sent to the configured e-mail address.
2. Video Loss
Check off the Video Loss checkbox in the Enable Email for Video Loss frame. When video loss is detected on one
or more channels, an e-mail alert will be sent to the configured e-mail address.
3. Scheduled Server Status
This section allows the user to configure scheduled e-mails to provide the server status. The email includes a snapshot
from the specified channel. To have the DVMS send server status e-mails, fill in Server Status section:
a. Check off the Send Email checkbox to enable server status e-mail alerts
b. Select the frequency of the automatic e-mails (1-24 hours) in the Send Email Every field. In the example above,
the server status email will be sent out every hour.
141
E-Mail Setup