i3 International SRX PRO User Manual page 70

Chapter 1. SRX-Pro Server
Tip
To activate Full Screen Settings, the motion
detection has to be drawn and selected in
the live view window.
When configured, this function will display the configured channel in full screen mode every time motion is detected in
the selected motion detection zone(s). Note that if audio is configured for this channel, it will also be heard as long as
the channel remains in the full screen mode.
To configure the full screen function, do the following:
1. Draw and select the desired motion detection area on the live view screen
2. Check Enable Full Screen checkbox to enable the full screen on motion function for the selected area
3. In the Full Screen Channel drop-down menu choose the video channel that will be displayed in Full Screen mode
when motion is detected on the selected area. The channel that will be displayed in Full Screen mode does not have
to be the same channel, where the motion has occurred.
4. Set the Dwell Time (sec) for the Full Screen Channel function. In the example above, Channel 1 will remain in Full
Screen mode for 5 seconds, after motion has been detected in the Area No. 1 on Channel 1.
5.
Click the Save button to save the configured settings
1.4.5.3. Setup For All Channels
To configure all channels, do the following:
1. Choose the Color Of All Motion Areas On Live Mode between Green and Red depending on personal esthetical
preferences. When the motion is detected on a specific camera, the triggered motion detection zone will be highlighted
on the main screen in the chosen color.
2. Check the Display Motion Area On Live Mode checkbox to display the motion detection area outline on Live
Mode when the motion is detected.
3. Click Area Draw to select the entire screen on all channels for motion detection
4. Click Area Clear to clear all selected zones on all channels. This will disable motion detection
5.
Click the Save button to save the configured settings
66
Motion Setup