Replacing A Hard Disk Drive - Sun Microsystems SPARCstation 5 Service Manual

4. A latch is located at the rear of the drive. Press the plastic latch to release the
drive handle.
5. Lift the drive handle to its vertical position.
When lifted, the drive bracket acts as a lever to disconnect the drive from the
chassis connector on the SCSI backplane.
6. Grasp the drive bracket handle and lift the drive straight up and out of the
chassis.
Place it on an antistatic surface. See Figure 9–2.
Figure 9–2 Removing a Hard Disk Drive
7. Repeat Steps 4 through 6 to remove the bottom disk drive (if necessary).

Replacing a Hard Disk Drive

Note - No jumper settings are required for the hard drives.
69
Storage Devices