Replacing The Power Led - Sun Microsystems SPARCstation 5 Service Manual

Figure 8–3
5. The LED is at the shrink-wrapped end of the speaker/LED cable. Using the tip
of a small, flat-blade screwdriver, work the cable and LED free from the plastic
tabs that hold them in place.
See Figure 8–4.
6. Remove the LED and attached cable segment from the system chassis.

Replacing the Power LED

1. Position the replacement LED/cable assembly so that the LED contacts the LED
light pipe. Then press the cable between the LED tabs to secure it in place.
See Figure 8–4.
SPARCstation 5 Service Manual ♦ Revision A, August 1994
58
Power LED and In-line Connector