Replacing The Hard Disk Drive; Figure 9-11 Removing/Replacing The Disk Drive - Sun Microsystems SPARCstation Voyager Service Manual

FIGURE 9-11

Replacing the Hard Disk Drive

Caution – Handle the drive by its ends only. Do not press on the top of the drive.
1. Position the replacement drive so both screws line up with the mounting holes.
See
FIGURE 9-11
2. Tighten both screws to secure the drive into the unit.
3. Connect the SCSI cable to the drive.
See
FIGURE 9-9
inserted.
4. Close the system and power it on.
94 SPARCstation Voyager Service Manual • December 1994
Removing/Replacing the Disk Drive
.
. Align the cable to the connector carefully so that the cable is correctly
Screws
Disk drive