3. Holding the card at an angle to the rear panel, insert the tabs on the card
backplate into the corresponding slots on the rear panel.
See Figure 11–7.
Figure 11–7
4. Carefully align the SBus card connector with the socket on the system board.
Press the corners of the card to push the connector into the socket.
See Figure 11–7.
Caution -
you may damage the pins on the card.
SPARCstation 5 Service Manual ♦ Revision A, August 1994
106
Inserting the SBus Card
Do not force the card. Align the card connector and socket properly or