4. Remove the diskette drive.
See "Removing the Diskette Drive" on page 75.
5. Unplug the diskette data cable from the system board.
See Figure 9–25.
6. Carefully note how the diskette data cable is routed, and remove it from the
system chassis.
Figure 9–25
System Board Cable Routing
Replacing the Diskette Data Cable
1. Route the replacement cable in the same manner as the defective cable that you
just removed.
The 90-degree bend in the cable should run directly beneath the diskette drive.
2. Connect the diskette data cable to the system board.
93
Storage Devices