Sun Microsystems SPARCstation 5 Service Manual page 125

Note -
Before installing the S24 card, inspect the AFX Bus slot for bent pins. Do
not install the S24 card if a pin in the slot is bent. If necessary, straighten bent
pins with needlenose pliers.
3. Holding the replacement S24 card at an angle to the rear panel, insert the tabs
on the card backplate into the corresponding slots on the rear panel.
See Figure 11–12.
Figure 11–12 Inserting the S24 Frame Buffer Card
4. Carefully align the S24 card connector with the AFX Bus slot on the system
board. Press evenly on the corners of the card to push the connector into the
socket.
See Figure 11–13.
System Board and Component Replacement
111