Figure 9–1
Removing a Hard Disk Drive
1. Shut down and power off the system.
See "Powering Off the System" on page 43.
2. Remove the cover and attach a wrist strap.
See Chapter 7.
3. Determine which drive you need to remove.
If you need to remove the bottom disk drive, follow the steps to remove the top
disk drive first.
Note -
drive automatically becomes SCSI address 3 on installation. The top drive
becomes SCSI address 1 on installation. SCSI termination for internal drives is
provided automatically by the SCSI backplane.
Caution -
not change the position of that drive.
SPARCstation 5 Service Manual ♦ Revision A, August 1994
68
Drive Locations
The position of a drive determines its SCSI target address. The bottom
Once a hard drive has been installed in the SPARCstation 5 system, do