Sun Microsystems SPARCstation 5 Service Manual page 117

a. Bend one leg of the extractor slightly to the outside until the hook clears the
hole in the SBus card.
See Figure 11–3.
b. Remove the other side of the extractor, which should come out easily
without bending it.
Place the replacement SBus card on an antistatic surface.
Figure 11–3 Removing the Extractor From the SBus Card
5. Insert the legs of the card extractor into the holes on the faulty SBus card.
Use two extractors for a double-width card. See Figure 11–4.
System Board and Component Replacement
103